Polyester Eye And Eye Sling , Webbing Lifting Slings For Lifting
Equipment
WLL 11500 LBS
Width 4 Inch
Length As client request
Colour Yellow
Standard ASMEB30.9
Certification CE GS TUV ISO
Safety Factor 5 to 1 Class 7, we can produce class 5 as well.
Package Film shrinked with outer carton and Pallet 20 Pallets per
20 feet container
1 100% high tenacity polyester fiber. Double A Class raw material
fiber
2 Double Plies slings. Of course , we can make one ply, three plies
and four plies as well.
3 With reinforcement on lifting eyes.
4 100% polyester sewing thread
Flat Eye & Eye Lifting Slings
Flat Eye & Eye (EE) lifting slings are made with a flat loop eye on
each end. The slings have a loop eye opening on the same plane as
the sling body.
This type of sling goes by a variety of names including flat eye
and eye, eye and eye and double eye sling.
The flat eye and eye slings are versatile and flexible. They can be
used with all three hitches: vertical, basket and choker.
Features
Single Use - One Way
Low cost, simple design
Easy to use
Stronger and more compact than rope or wire rope alternative
solutions.
Can be attached or built in to a structure or load, but must only
be used to perform a single complete lift.
Saves time and cost on-site slinging and reslinging loads.
Fully manufactured, labelled and tested in accordance with BS EN
1492-1:2000 or upon request, manufactured to your commercial
specifications with supporting technical file.
Available as standard in 25mm, 35mm and 50mm widths in endless
format or as bespoke units with loops each end.
WARNING
Inspect slings each day before use, looking for:
Missing or unreadable ID tag
Melted, charred or weld-splattered areas
Acid or alkali burns
Holes, tears, cuts, snags or embedded particles
Broken or worn stitching
Excessive abrasive wear or elongation
Knots or brittle areas
Broken, corroded, pitted distorted fittings
Do not use worn or damaged slings or attachments. Discard or repair
them. Use damaged slings only after they are repaired,
reconditioned, and proof tested by the sling manufacturer or a
qualified person. Keep certificates of proof test.
Maintenance requirements are minimal. Belt slings may be cleaned
with clear water. Remember weak chemical
solutions will become increasingly stronger by evaporation.
Regularly inspect belt slings and, in the event of the
following defects, refer the sling to a Competent Person for
thorough examination: illegible markings; damaged,
chaffed or cut webbing; damaged or loose stitching; heat damage;
burns; chemical damage; solar degradation;
damaged or deformed end fittings.
Inspect slings each day before use, looking for:
Missing or unreadable ID tag
Melted, charred or weld-splattered areas
Acid or alkali burns
Holes, tears, cuts, snags or embedded particles
Broken or worn stitching
Excessive abrasive wear or elongation
Knots or brittle areas
Broken, corroded, pitted distorted fittings
Do not use worn or damaged slings or attachments. Discard or repair
them. Use damaged slings only after they are repaired,
reconditioned, and proof tested by the sling manufacturer or a
qualified person. Keep certificates of proof test.
Maintenance requirements are minimal. Belt slings may be cleaned
with clear water. Remember weak chemical
solutions will become increasingly stronger by evaporation.
Regularly inspect belt slings and, in the event of the
following defects, refer the sling to a Competent Person for
thorough examination: illegible markings; damaged,
chaffed or cut webbing; damaged or loose stitching; heat damage;
burns; chemical damage; solar degradation;
damaged or deformed end fittings.
